User Manual
Table Of Contents
- 页 1
- 页 2
- 页 3
- 页 4
- 页 5
- 页 6
- 页 7
- 页 8
- 页 9
- 页 10
- 页 11
- 页 12
- 页 13
- 页 14
- 页 15
- 页 16
- 页 17
- 页 18
- 页 19
- 页 20
- 页 21
- 页 22
- 页 23
- 页 24
- 页 25
- 页 26
- 页 27
- 页 28
- 页 29
- 页 30
- 页 31
- 页 32
- 页 33
- 页 34
- 页 35
- 页 36
- 页 37
- 页 38
- 页 39
- 页 40
- 页 41
- 页 42
- 页 43
- 页 44
- 页 45
- 页 46
- 页 47
- 页 48
- 页 49
- 页 50
- 页 51
- 页 52
- 页 53
- 页 54
- 页 55
- 页 56
- 页 57
- 页 58
- 页 59
- 页 60
- 页 61
- 页 62
- 页 63
- 页 64
- 页 65
- 页 66
- 页 67
- 页 68
- 页 69
- 页 70
- 页 71
- 页 72
- 页 73
- 页 74
- 页 75
- 页 76
- 页 77
- 页 78
- 页 79
- 页 80
- 页 81
- 页 82
- 页 83
- 页 84
- 页 85
- 页 86
DESIG N IN SP IRATION
Ampero Tools
LOOPER
In default mode, pressing footswitch 3 and the CTRL footswitch together will open the looper menu.
The progress bar at the top will be shown in red during recording and overdubbing. It will be shown in green in play mode.
Footswitch 1 controls start (yellow LED) and stop (yellow LED closed) for half speed playback. Footswitch 2 controls the start (white LED) and stop (white
LED closed) for reverse playback. These footswitch controls correspond with the 1/2 SPD and REV buttons on the touchscreen.
Quick access knob 1 adjusts the loop recording level from 0-99.
Quick access knob 2 selects between setting the loop before (Pre) or after (Post) your effects chain.
• In Pre mode, the looper will record mono audio without any effects, up to 100 seconds.
• In Post mode, the looper will record stereo audio with effects, up to 50 seconds.
Quick access knob 3 adjusts the loop playback volume from 0-99.
Exit the looper by pressing BACK on the upper left of the screen.
Exit looper
Currentlooperstatus
1/2speed on/off switch
Reverseon/offswitch
Record/playtime
Clearallrecordeddata
Record/playprogressbar
Previouspatch
Nextpatch
Switcheslooperposition
(pre/posteffects)
ControlslooperplaybacklevelControlslooperrecording level
11