Momentary Footswitch Opareting Guide For Ampero & Ampero One DESIGN INSPIRATION The contents of this manual are subject to change without notice.
1 Preface This operating guide is for how to set the Ampero Switch on Ampero or Ampero One. On both units, Ampero Switch is connected and set in the same way, so the following steps will take Ampero as an example. If you want to set the Ampero Switch to control other device, please refer to the related contents of your device manual. How to connect Connect one end of the TRS jack to Ampero Switch and the other end to the EXP 2 / FS jack of Ampero with the provided TRS cable. 1/4"(6.
2 How to set up 2. “FS5 TAP” and “FS6 TAP” in the selection panel will become editable (“FS4 TAP”, “FS5 TAP” in Ampero One). The default is set to bank-/+. 3. “FS5 TAP” corresponds to Ampero Switch Footswitch A and “FS6 TAP” corresponds to Ampero Switch Footswitch B.
