User Manual

Connect Ampero’s balanced or unbalanced outputs to your mixer or audio interface’s corresponding inputs. Use the balanced outputs for optimal

signal to noise ratio. If you want to send a mono signal out, use Ampero’s left output channel. To prevent damage to your equipment, make sure the

mixer or interface channel’s volume is muted before making any connections.

If you experience unwanted noise when using the balanced outputs, it is likely produced by the ground loop. In this case, turn on Ampero’s GND LIFT

switch.

Turn the Ampero output volume all the way down before connecting headphones to prevent harm to your ears. Ampero’s headphones out comes

with hi-fi stereo sound.

For best results with headphones, turn on Ampero’s AMP and CAB modules.

Connecting your mixer, interface, headphones, and other equipment

DES I GN IN S PIRAT ION

Suggested Setups