User Manual

Customizing Your Ampero
About
About will show you information about Ampero’s firmware.
Factory Reset
Use this menu to perform a factory reset. Remember, resetting
Ampero will delete all of your saved changes and personal settings.
Once it is executed, it cannot be undone, so please back up your
settings before performing a factory reset.
Press Factory Reset on the screen.
When the factory reset is complete, this message
will appear. Press OK to return to the main menu.
EXP 2/FS
You can also connect external footswitches to EXP2/FS jack for
further control. This menu allows you to set up the working mode of
EXP 2/FS jack and the functions of external footswitches.
The menu includes MODE, FS5 TAP, FS6 TAP, BANK SEL MODE.
Select a mode from EXP (connect to expression pedal), Single FS
(single footswitch controller) and Dual FS (dual footswitch controller).
The MODE selection affects available options in this menu:
EXP: all other options are unavailable
Single FS: FS6 TAP is unavailable
Dual FS: all other options are available
FS5 TAP and FS6 TAP can be set up as follows:
Loop Rec/Play: Record/play loop phrases
Loop Stop: Stops looper playback
Looper Menu: Enter/exit looper menu
Drum On/Off: Drum rhythm play/stop
Drum Menu: Enter/exit drum menu
Tuner: Enter/exit tuner
Tap Tempo: Tap tempo function
Patch+/Patch-: Change patches by toggling up or down
Bank+/Bank-: Change banks by toggling up or down
EXP1 on/off: Switching built-in expression pedal on/off
You can select Ampero’s bank select mode when using external
footswitches as a bank switcher. This works for external
footswitches only.
Bank Sel Mode lets you select from two modes: Initial and Wait.
In Initial mode, Ampero will jump to a new patch immediately after
switching a bank.
In Wait mode, when switching banks, the patch you’re using won’t be
changed (footswitch LEDs on Ampero will keep flashing) until you tap
a footswitch again to confirm your selection.
MIDI Channel
This menu allows you to set up Ampero’s MIDI channels, ranging
from Omni (all channels) to Channels 1-16. Default is set to Omni.
See page 42
.
DES I GN I NSP I RAT I O N
This display will come up with a warning.
Pressing YES will perform the factory reset. Pressing NO will return
to the previous menu. After continuing with the factory preset, this
screen will appear showing that reset is in progress. Do not
disconnect the power supply while the reset is in progress.
Disconnecting the power supply may cause Ampero to malfunction.
16