User Manual

Customizing Your Ampero
CTRL Settings
Use the CTRL Settings menu to assign a function to CTRL footswitch or select which modules of the current patch will be controlled by the CTRL footswitch.
•Function
Under the Function option you can assign a function to CTRL
footswitch. There are three FUNCTION selections:
Module/Tap: For controlling module on/off or tap tempo
Tap Tempo: For tap tempo only EXP 1
On/Off: For switching built in expression pedal on/off or tap tempo
When Module/Tap or EXP 1 On/Off is assigned to CTRL footswitch,
you can use CTRL footswitch to switch module/built-in expression
pedal on/off or tap tempo. You can press and hold CTRL footswitch to
switch between the two functions:
- Module on/off switch
Repeatedly pressing the CTRL footswitch will turn it on or off, with
green and red LED lights to show the on/off status respectively. The
modules it controls will be affected when switching CTRL switch
on/off. The CTRL footswitch is set on (green) by default. To set
target modules, see Module/Tap Target section below for detailed
info.
- EXP 1 on/off switch
Repeatedly pressing the CTRL footswitch will turn the built-in
expression pedal on or off, with green and red LED lights to show
the on/off status respectively.
- Tap Tempo
When Tap Tempo engaged, the footswitch LED will turn blue and
will flash with the tempo set. Set the tempo by repeatedly tapping
the footswitch. This tempo will apply to the delay time and other
effects with adjustable speed parameters.
• Module/Tap Target
Use the Module/Tap Target menu to select which modules of the
current patch will be controlled by the CTRL footswitch:
The 9 Ampero effects modules are listed in the panel, with yes and
no below each module to show if the CTRL footswitch is activated or
not. In the example image above, FX1, FX2 and AMP modules are
controlled by the CTRL footswitch.
Use the quick access knobs to change between yes/no, and press the
arrows on the right/left to scroll through the modules.
DES I GN I NSP I RAT I O N
10