Getting Started Guide

www.hotoneaudio.com
Bluetooth MIDI Controller
技术要求：
157g铜板纸，273*124mm，四色印刷，覆哑膜，二折页
Screen Display Getting Started
The Bluetooth indicator (the dot shown
above) will flash when Ampero Control
is in Bluetooth Pair Mode (hold FS 2+3).
PC CC
PC CC
Thisindicatesa
PCmessage(PC
16)hasbeensent
ThisindicatesaCC
message(CC112)
hasbeensent
MIDI
PC CC PC CC
PC CC PC CC
Bluetoothnot
connected
Bluetooth
connected
Bluetooth
PC CC PC CC
Thisindicatesunitbank
change
(bank00tobank01)
Bank
Notes: 1. You can enter offline mode if
no device is found.
2. Ampero Control can only be edited
by one device at a time. To use other
devices, tap “Settings”icon on lower
right corner of the screen, find
“Connection Status” and enter, then
tap “Disconnect”. Connect another
device when finished.
3. The default device name is Ampero
Control. You can customize your
device name if needed.
1. Turn on the Bluetooth switch on your mobile device, then turn
on your Ampero Control and launch the app.
2. Login your account (optional).
3. Press and hold FS 2+3 on your Ampero Control to enable
Bluetooth Pair Mode. A dot will flash on the bottom right
corner on the screen of your unit to indicate pairing status on.
4. When your Ampero Control appears listed on the startup
page, select and tap the “Connect To The Selected Device”
button on the screen. If search failed, you can retry searching
by manually tap “Search Again” button.
折起朝外