Manual

1967-1969 GM F Body
Hotchkis Performance LLC. 2
2R. Jack up the vehicle and properly support with jack stands or lift jacks. Make sure the
rear end is supported with the vehicle’s load on the leaf springs. This is to ensure you
install the rear bar in the proper position.
3R. Take the 7/8” bushings and grease the inner surface with the included white silicon
grease.
4R. Install the bushings on the bar. (4) Place the bracket over top of the bushing. (5)
5R. After you determine there’s enough clearance for the bar, note the approximate
location of the sway bar axle bushings.