User Manual

1110 66-70 B-Body, 70-74 E-Body
Hotchkis Performance LLC. 5
7. Install A-Arm Front Mount
Use hardware kit 17101 and install the split lock washer & AN washer onto each
½” socket-head bolt. Included in you’re A-Arm kit will be an assortment of
aluminum spacers with varying thicknesses. Grab one 0.185” spacer for each
Relocator. NOTE: If your mount came pre-assembled by Hotchkis, please use
the spacer that was installed on the mount. Insert the socket-head bolt slightly
into the bottom hole of the A-Arm Relocator just enough so you can rest the
spacer on the tip of it on the inside of the Relocator as shown below. Next, slide
the A-Arm into place, slide bolt all the way through, then fully tighten to 35-40 ft-
lbs. See bottom picture for full detail.
Passenger side shown here
Stack Up: 3/8” bolt---Split Lock washer---AN Washer---Relocator Bracket---
Spacer---Misalignment Spacer---Heim Joint