Owners manual

4 of 9
Rear Bar Installation
1. Using a 18mm combination wrench and a T-40 torx driver & ratchet,
remove the lower end link nut. Use a spray lubricant to help the removal.
2. Remove the two upper 18mm bolts that hold the sway bar to the frame.
3. Using a 15mm ratchet and a 18mm wrench, take off the lower nut that
remains on the lower sway bar frame mount. DO NOT remove the bolt; it
holds the lower A-Arm in the car.
4. Push out the lower end link studs and remove the bar from vehicle.
1
2
3
4