Owners manual

13) Next, fully tighten the jam nut on the end link using an 11/16” open-end wrench. Make sure the heim
joint is centered. You may need a flat screw driver or similar tool to hold the heim joint in positioned
while you tighten the jam nut.
14) Check all hardware once again to make sure everything is tight.
Enjoy you new tubular sway bar kit from Hotchkis! If you need assistance with the install or have any other
questions, go to the “instructions” button on our site or call us at the number below.
Thank you for choosing the best sway bar kit available for your E46 M3!
Hotchkis Performance
562.907.7757
www.hotchkis.net
12035 Burke St. Suite 13
Santa Fe Springs, CA 90670