Owners manual

29) Reinstall the plastic undertray using the stock hardware.
30) Lower the car and from inside, reconnect the steering shaft and replace the plastic
cover.
31) After driving the vehicle, re-check all hardware for tightness. You are finished with
the front sway bar installation
IMPORTANT: For maintenance, use the zerk fittings to grease the bushings at least once a
year (15,000 miles) or when excessive noise occurs. Use a silicone based grease only ! A
lithium-based grease can wash out with water and should not be used.
MOVE ON TO THE REAR SWAY BAR INSTALLATION
Please call us at (877) 4NO-ROLL if you have any questions regarding your Hotchkis
products.