Use and Care Manual

All references to the HL400 also apply to the HL800

Quick Start Guide

Unpack:

Cut packaging tape and open the top aps of the shipping box.

With aps open, carefully ip the box up-side down onto a counter top.

Carefully lift the box upward, sliding the box o the HL400 .

Remove the remaining packaging materials from around and inside the HL400 unit and store

them with the box.

Important: Keep the original shipping box and packaging material in case you need to ship the HL400

Plug In + Turn On:

Plug the HL400 into a standard 3-prong, grounded, 110V wall outlet.

Flip the power switch to the ON position.

The HL400 will run a quick start-up light check - RED lights for 1 second, BLUE lights for 1 second

then a pulsing RED light when a Smart Shelf enters power-save mode and is ready to accept a meal. If the

Smart Shelf is below room temperature it will have a solid BLUE light, indicating that it is in Warm-Up

mode and not ready to accept a meal.

Warm Up:

After the HL400 has been turned on, the unit may require a few moments to warm-up and normalize

the temperature of all the Smart Shelves. This process usually takes 1-2 minutes. During this time the

Smart Shelves will display a solid BLUE light, indicating it is in Warm-Up mode and not ready for a meal.

Warm Up Completed:

The HL400 warm-up cycle will be complete when all the Smart Shelves display RED lights. Do not

load any meals in the HL400 until the warm-up cycle is complete for all Smart Shelves.