Instructions for use

If a button is pressed and the light fails to come on, check the appliance is plugged in and the power is

switched on.

If the milk is not foaming properly, check that the blender is correctly placed on the spigot in the pot. Check

that the blender is not broken or that the blender has become jammed. Replace the blender.

If the blender fails to rotate when the appliance is operating, stop the appliance and check that the blender is

correctly placed on the spigot in the pot. Press the blender firmly down onto the spigot and retry the appliance.

If this fails, replace the blender to check whether this resolves the problem.

New blenders are available as a spare part.

If the Milk Frother has been restarted on a hot setting whilst the unit was still hot then it will not operate for a

third time. Under this condition the

button can still be selected/ When the or button is pressed

the light will flash 3 times. This indicates that the appliance needs to cool down for approximately 5 minutes.

Refilling the pot with cold milk will reduce the time required before the Milk Frother can be restarted.

If the appliance still fails to work, please contact the Hostess customer service department.

TECHNICAL SPECIFICATION

Electricity Range: 220 - 240V 50Hz

Power: 600W

Capacity: 100 - 250ml cold beverage

U.K. WIRING INSTRUCTIONS

The wires in the mains lead are coloured in accordance with the following code:

BLUE NEUTRAL

BROWN LIVE

GREEN/YELLOW EARTH

As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings

identifying the terminals on your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or

coloured black.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or

coloured red.

The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with the

letter E or

and is coloured GREEN or GREEN/YELLOW

WARNING: THIS APPLIANCE MUST BE EARTHED

ENVIRONMENTAL NOTE

This symbol on the product indicates that it must not be discarded as general household waste.

Instead it should be handed over to the applicable collection point for the recycling of electrical and

electronic equipment. Disposal must be carried out in accordance with local environmental

regulations for waste disposal.