Instructions for use

Note: If the button marked is pressed again whilst the Milk Frother is still hot, then the unit will

operate and automatically switch off when the milk reaches the pre-set temperature (

~70ºC).

2. Frothing Hot Chocolate

Fig.7 Remove the lid.

Fig.8 Press the blender firmly onto the spigot in the bottom of the pot. Check that it rotates freely.

Fig.9 Pour the required amount of milk into the pot, up to the 250ml Max level.

(If more milk is poured into the pot you risk the beverage overflowing!)

Fig.10 Pour the chocolate into the pot.

Fig.11 Replace the lid.

Fig.12 Place the pot onto the base unit. Plug in the appliance and switch on the mains supply.

Fig.13 Select the button marked

. The indicator light will come on and the blender will start to rotate the

milk. After approximately 1½ - 4 minutes the hot chocolate will have reached the pre-set temperature (~70°C)

and the appliance will automatically switch off. The luscious hot chocolate can now be poured into your cup. If

you want to stop the appliance at any time, press the button a second time.

Note: If the button marked

is pressed again whilst the Milk Frother is still hot, then the unit will operate

and automatically switch off when the milk reaches the pre-set temperature (~80°C)

CHANGING THE BLENDER/STIRRER

The Milk Frother is supplied with two blenders, marked ’foam’. These will produce a frothy drink. The stirrer

marked ’mix’ can be used to produce a hot drink that is not frothy.

Note - If you wet the bottom of the pot with a little tap water this will speed up

the heating operation.