Service Manual
Table Of Contents
- SERVICE MANUAL FOR MODEL RM-45-SD
- REQUIRED TOOLS
- REQUIRED EQUIPMENT
- CONTENTS
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- Slide Number 35
5. Remove the high intensity LED flexible strip by
pulling it out from its base. Repeat this step to
remove the other high intensity LED flexible strip.
DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
Instructions to Replace High Intensity LED Flexible Strips .
4. Disconnect the LED strip Light’s electrical
connector .
6. To install the
new high
intensity LED
flexible strip,
reverse the
previous steps.