Service Manual

8. Pull both ambient
sensors through the
cut out of display .
Once the splice is
visible, remove the
tape and damage
sensor and connect the
new, and reverse the
previous steps to install
the thermostat.
7. Use masking tape to splice
the damaged ambient
sensor with the new. This
operation will serve as
guide to remove the
damage sensor and
connect the new to the
connector of the
thermostat.
DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
Instructions to replace Ambient Sensor.
6. Pull out the ambient
sensor from its plastic
clip support.
5. Unscrew the two screws
that hold in place the light
switch support plate on the
baffle using a Phillips
screwdriver # 2 .