Instruction Manual

16
This controller has a feature to reduce energy consumpon during the
closing hours of your locale. To acvate this feature press the ES buon
on the controller. In this refrigerator, the Energy Saving mode has been
programmed to turn o the lights for one hour, or unl the door is opened.
The Energy Saving mode can also be deacvated by pressing the ES buon,
which will turn the lights back on.
1. Plug in the electrical cord of the unit to a wall outlet, following the
recommendaons about electrical installaon in this manual.
2. Let the cooler run with no product load for 2 hours, or let the
compressor complete three on/o cycles to assure that the
temperature inside is appropriate for the products before loading
them into the refrigerator.
3. Verify the internal illuminaon operaon by acvang the on and o
switch.
4. When placing products in the cooler, you should leave small gaps
between one and the other to assure free circulaon of air inside the
cabinet.
5. Do not leave the door open for extended periods of me, to avoid
increased temperature of the products.
6. Do not unplug your cooler during the night, since when you turn it
back on during the day the electrical consumpon will increase.
The temperature of a cooler should be between 34°F to 40°F.
USE OF YOUR COOLER WITH CAREL
ELECTRONIC THERMOSTAT
These coolers are provided with a versale electronic thermostat that
allows to cool dierent beverages.
To turn off the lights of the
cooler press the light bulb
symbol.
ENERGY SAVING MODE
SELECTOR
START UP THE COOLER
THIS EQUIPMENT IS INTENDED FOR THE STORAGE AND DISPLAY OF
NON-POTENTIALLY- HAZARDOUS BOTTLED OR CANNED PRODUCTS ONLY