Service Manual
Table Of Contents
- SERVICE MANUAL FOR MODEL RM-10
- REQUIRED TOOLS
- REQUIRED EQUIPMENT
- CONTENTS
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- Slide Number 29
1. Use a slotted
screwdriver to pull out
the LED cover profile.
Instructions to Replace LED Strips.
2. Disconnect the LED
electrical connector.
3. Use a slotted
screwdriver to pull out
the LED strip.
4. To install the new LED
strip reverse the
previous steps.
LED cover
profile
DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE