Service Manual
Table Of Contents
- SERVICE MANUAL FOR MODEL RM-10
- REQUIRED TOOLS
- REQUIRED EQUIPMENT
- CONTENTS
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE
- Slide Number 29
5. Unscrew the two screws that hold in
place the light switch support plate on
the baffle using a Phillips screwdriver # 2 .
6. Pull out the ambient sensor from its
plastic clip support.
7. To install the new ambient sensor
reverse the previous steps.
Instructions to replace Ambient Sensor.
DISCONNECT UNIT FROM POWER SUPPLY BEFORE DOING ANY SERVICE