Service Manual

52
5) Make sure at least 3 minutes have elapsed since you turned off the power supply. Make
surethecontrolswitchisinthe"ICE"position.Replacethefrontpanelinitscorrect
position and turn on the power supply.
6) Blow the icemaker water supply line out using the compressed air or carbon dioxide
supply.
7) Close the icemaker water supply line drain valve.
2. Drain the water tank:
1) Turn off the power supply.
2) Remove the front, top, and left side panels, then remove the insulation panel.
3)Movethecontrolswitchtothe"OFF"position.
4) Disconnect the distributor from the distribution hose. Remove the thumbscrew securing
cube guide B. Remove cube guide B, then remove cube guide A. Remove the overow
cap and overow pipe.
5) Remove the drain plug. Allow the water tank to drain, then replace the drain plug in its
correct position. Be careful not to cross thread it.
6) Replace the overow pipe, overow cap, cube guide A, cube guide B in their correct
positions. Be careful not to cross thread the overow pipe.
7) Reconnect the distributor to the distribution hose.
8) Replace the insulation panel, then replace the left side, top, and front panels in their
correct positions.
9) Remove all ice from the dispenser unit/storage bin. Clean the dispenser unit/storage bin
using a neutral cleaner. Rinse thoroughly after cleaning.