Service Manual

51
B. Maintenance
This icemaker must be maintained individually, referring to the instruction manual and labels
provided with the icemaker.
WARNING
1. Only qualied service technicians should attempt to service this icemaker.
2.Movethecontrolswitchtothe"OFF"positionandturnoffthepowersupplyto
the SRK condensing unit before servicing the KMS or SRK. Place the KMS
disconnect (if applicable) in the off position. Lockout/Tagout to prevent the
power supply from being turned back on inadvertently.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean, soft cloth. Use a damp
cloth containing a neutral cleaner to wipe off oil or dirt buildup.
2. Dispenser Unit/Storage Bin and Scoop
•Washyourhandsbeforeremovingice.Usetheplasticscoopprovided(binaccessory).
•Thedispenserunit/storagebinisforiceuseonly.Donotstoreanythingelseinthe
dispenser unit/storage bin.
•Cleanthescoopandthedispensingunit/storagebinlinerusinganeutralcleaner.
Rinse thoroughly after cleaning.
4. Condenser
Check the condenser once a year, and clean the coil if required by using a brush or
vacuum cleaner. More frequent cleaning may be required depending on location.
C. Preparing the Icemaker for Long Storage
NOTICE
1. When storing the icemaker for an extended time or in sub-freezing
temperatures, follow the instructions below to prevent damage.
2. To prevent damage to the pump motor seal, do not operate the icemaker with
thecontrolswitchinthe"WASH"positionwhenthewatertankisempty.
When the icemaker is not used for two or three days under normal conditions, it is sufficient
tomovethecontrolswitchtothe"OFF"position.Whenstoringtheicemakerforanextended
time or in sub-freezing temperatures, follow the instructions below.
1. Remove the water from the icemaker water supply line:
1) Turn off the power supply and remove the front panel.
2) Close the icemaker water supply line shut-off valve and open the icemaker water supply
line drain valve.
3) Allow the line to drain by gravity.
4) Attach a compressed air or carbon dioxide supply to the icemaker water supply line
drain valve.