Service Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- II. General Information
- A. Construction
- B. Sequence of Operation
- C. Control Board
- 1. Control Board Layout
- 2. LED Lights and Audible Alarm Safeties
- 3. Controls and Adjustments
- a) Default Dip Switch Settings
- b) Harvest Timer (S4 dip switch 1 & 2)
- c) Pump-Out Timer (S4 dip switch 3 & 4)
- d) Pump-Out Frequency Control (S4 dip switch 5 & 6)
- e) Harvest Pump Timer (S4 dip switch 7)
- f) Factory Use (S4 dip switch 8)
- g) Freeze Timer (S4 dip switch 9 & 10)
- h) Float Switch Control (S5 dip switch 1)
- i) Refill Counter (S5 dip switch 2 through 5)
- D. Control Switch
- III. Technical Information
- IV. Service Diagnosis
- V. Replacement of Components
- VI. Cleaning and Maintenance
34
13) If BC assembly was removed, replace BC assembly in its correct position.
14) Replace the control box cover in its correct position.
15) Replace the panels in their correct positions.
16) Turn on the power supply to start the automatic icemaking process.
Legend: BC–bin control; CB–control board
Fig. 1
Bin Control
Proximity
Switch Closed
(calling for ice)
Bin Control Cable
Bin Control Proximity
Switch Open
(bin full, unit off or
shutting down)
Bin Control
Extension Bracket
Fig. 2
Actuator Paddle
Bin Control Cover
Bin Control Extension Bracket
Bin Control
Bin Control Insulation