Service Manual
Table Of Contents
- Important Safety Information
- I. Construction and Water/Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- A. Control Board Layout
- B. LED Lights and Audible Alarm Safeties
- C. Settings and Adjustments
- 1. Default Dip Switch Settings
- 2. Harvest Timer (S4 dip switch 1 & 2)
- 3. Pump-Out Timer/Harvest Time During Pump-Out (S4 dip switch 3 & 4)
- 4. Pump-Out Frequency Control (S4 dip switch 5)
- 5. Harvest Pump Time (Harvest Assist Duration) (S4 dip switch 6)
- 6. Harvest Pump Time (Harvest Assist)/Freeze-Time Correction (S4 dip switch 7)
- 7. Factory Use (S4 dip switch 8)
- 8. Freeze Timer (S4 dip switch 9 & 10)
- 9. Float Switch Control Selector (S5 dip switch 1)
- 10. Refill Counter (S5 dip switch 2 and 3)
- 11. Minimum Harvest Time (S5 dip switch 4)
- 12. Anti-Slush (S5 dip switch 5)
- IV. Refrigeration Circuit and Component Service Information
- VII. Disposal
- VIII. Technical Information
50
Inlet Water Valve Tee
Inlet Water Valve
Wash Valve
Drain Valve
Float Switch Vent Hose
Drain Hose Tee
Fig. 5
Wash Valve Hose
Pump Suction Hose
Fig. 6
Float Connection Hose
Water Tank Drain Hose
Drain Pipe
Water Tank
Bottom View
Front View
2. Remove the water from the water tank:
17) Remove the insulation panel and front frame.
18) Disconnect the hoses connected to the water tank. Allow the tank and hoses to drain
completely. See Fig. 6.
19) Remove all ice from the dispenser unit/storage bin and clean the dispenser unit/storage
bin liner using a neutral cleaner. Rinse thoroughly after cleaning.
20) Reconnect the hoses to the water tank.
21) Replace all removed parts and panels in their correct positions.