Instruction Manual

13
g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the
thermostat extension bracket (stainless). See Fig. 4. Use the 2 screws to attach the
"Z" bracket (plastic) to the thermostat extension bracket (stainless).
h. Use the two 4×10 stainless steel screws
in the accessory bag to attach the
thermostat bulb attachment (with attached
thermostat bulb) to the "Z" bracket.
i. Remove the 2 screws from the lower part
of the thermostat bracket (plastic) and use
them to attach the thermostat extension
bracket (stainless) to the thermostat
bracket (plastic).
j. Make sure the silicone hose is in place to
prevent ice from striking the capillary tube.
2. Bin Control Installation
NOTICE
Before operating the icemaker, the bin control must be installed. Failure to properly
install the bin control could result in ice backup and icemaker damage.
1) Install the bin control thermostat as follows:
a. Remove the baffle from the bin (if applicable).
b. Remove the tie securing the bin control thermostat assembly. Remove the
2 thumbscrews and the "Z" bracket. See Fig. 3.
c. Remove the bin control thermostat assembly from the shipping hook. Lower the
thermostat extension bracket (stainless) with the thermostat bulb attachment and
thermostat bulb through the hole located at the bottom of the icemaker. Next, lower
the thermostat bracket (plastic) through the hole.
d. Slide the left side of the upper part of the assembly towards you and make sure it
is hooked on the wall. Make sure the left side and bottom of the assembly are ush
against the wall and base panel.
e. Secure the assembly in place with the thumbscrews (unless you are installing an
upper unit).
f. Insert the plug into the receptacle on the assembly until it locks into place.
Note: Icemaker will not run if the plug is not in the receptacle.
Fig. 3
Bin Control
Thermostat
Assembly
Shipping Hook
Thermostat Bracket
(plastic)
Tie
"Z" Bracket
Thermostat Bulb
Attachment
(plastic) and
Thermostat Bulb
Thumbscrews
Thermostat Extension
Bracket (stainless)
Hole
Plug
Receptacle
Thumbscrews
Hook
Bushing
Fig. 4
Thermostat Bracket
(plastic)
Thermostat Bulb
Attachment (plastic)
"Z" Bracket (plastic)
Thermostat Extension
Bracket (stainless)
Silicone Hose