Instructions

Icemaker Water

Supply Inlet

1/2” FPT

Icemaker Drain

Outlet

3/4” FPT

Icemaker Water Supply Line

Shut-Off Valve

Icemaker Water Supply Line

Drain Valve

Bin Drain Outlet

3/4”FPT

Bin

2-inch

(5-cm)

air gap

Separate piping to approved

drain. Leave a 2-inch (5-cm)

vertical air gap between the

end of each pipe and the drain.

Drain

Floor

KMD-410MAH

Fig. 9

Icemaker

Vent Tube

Minimum 1/4” Nominal ID

Copper Water Tubing

Minimum 3/4” Nominal ID

Hard Pipe

1. Icemaker

• Icemaker water supply inlet is 1/2” female pipe thread (FPT). A minimum of 1/4” nominal

ID copper water tubing or equivalent is required for the icemaker water supply line.

• An icemaker water supply line shut-off valve and drain valve should be installed.

• Icemaker drain outlet is 3/4” FPT. A minimum of 3/4” nominal ID hard pipe or equivalent is

required for the icemaker drain line.