Instructions

10
E. Bin Control Installation
1) Remove the front panel, then
remove the front insulation.
2) Loosen the two thumbscrews
securing the pump motor bracket.
See Fig. 3.
3) Disconnect the discharge hose.
4) Disconnect the pump motor
connector and float switch
connector from the side of the
control box.
5) While pushing up the snap tab at
the right side of the pump motor
bracket, pull out the water tank,
cube guide, pump motor bracket,
pump motor and float switch
together. See Fig. 4.
6) Route the bin control lead through
the hole in the base, then into the
bushing provided. See Fig. 5.
Fig. 5
Bushing
Bin Control Lead
Fig. 3
Discharge
Hose
Float Switch
Connector
Pump Motor
Connector
Thumbscrews
Snap Tab
Pump Motor Bracket
Fig. 4
Float Switch
Pump Motor
Cube Guide
Snap Tab