Service Manual

26
Fig. 3
4) As water begins to ll the water tank (1-min. ll), place an object 5" to 7" (127 to
178mm) away from the bin control lens. See Fig. 3. 15 sec. later, the icemaker shuts
down. Remove the object from the bin control lens. 30 sec. later, the icemaker restarts.
Cycle at Bin
Control Activation
Shutdown
Fill Cycle 15 sec. after activation.
Harvest Cycle If engaged 15 sec. or longer, at the end of harvest cycle.
Freeze Cycle 15 sec. after activation if activated at least 15 sec. before the 5-min. short cycle
protection timer terminates. Otherwise, at the end of the next harvest cycle.
Ice Level in Bin Control Board
"OPEN/CLOSED" LED
Bin Control Controller
LED 1
Empty OFF ON
Full ON OFF
5) Once the icemaker restarts, move the control switch to the "OFF" position, then turn off
the power supply.
6) Replace the base cover in its correct position.
7) Move the control switch to the "ON" position. Replace the front panel in its correct
position, then turn on the power supply.
Bin Control Lens