Service Manual

31
A. Control Board Layout
16
"H" Control Board
Part Number P00013-0
"H" Control Board
1. Control Board Layout
"OUTPUT TEST" Button
(used to test relays on
control board)
K6 Connector
Open
K1 Connector
Pins
#1, 3 Float Switch
# Open
#4, 5 Bin Control
#6, 7 Thermistor
#8, 9 Open
"ALARM RESET" Button
S1 Dip Switch
"POWER OK" LED
(Lights when power is
supplied to the board.
Flashes when bin
control is activated.)
Relay LEDs (6)
(indicate which
relays are energized
as listed below)
LED 5 (X1 Relay)
Compressor (Comp)
Fan Motor-Remote
(FMR)
LED 4 (X6 Relay)
Drain Valve (DV)
LED 8 (X4 Relay)
Inlet Water Valve (WV)
(WV1) on units with
 inlet water valves
K7 Connector
Transformer
K3 Connector
Magnetic Contactor
LED 7 (X3 Relay)
Pump Motor (PM)
LED 6 (X2 Relay)
Hot Gas Valve (HGV)
Fan Motor (FM)
Liquid Line Valve (LLV)
(FM and LLV off when
LED on)
LED 9 (X5 Relay)
Inlet Water Valve
(WV) on units with
inlet water valves
K5 Connector
Pins
#1 Fan Motor (FM)
Liquid Line Valve (LLV)
# Hot Gas Valve
#3 Pump Motor
#4 Inlet Water Valve
#5 Open
#6 Drain Valve
S2 Dip Switch
Alarm Buzzer
(FM off when LED on)
Power Relay
Control Board
Part Number P01771-02
Type HKM2006V003