Service Manual

Table Of Contents
23
2. Bin Control Cleaning
Scale may build up on BC. Scale can cause the actuator paddle and magnet to stick.
Inthis case, BC should be cleaned.
WARNING
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after the icemaker is serviced. Make sure that none have fallen
into the dispense unit/ice storage bin.
1) Remove the louver, move the control switch to the "OFF" position, then unplug the
icemaker from the electrical outlet.
2) Clear any ice away from BC.
3) Disconnect the silicone hose and overow pipe. Allow the water tank to drain completely.
Next, remove the water tank by pressing down the snaps on the bracket (L) and (R),
pulling the water tank towards you slightly, and pushing it down. See Fig. 1.
4) Hold both sides of the mechanical bin control, then pull forward and remove. See Fig. 2.
Fig. 2
Bin Control Assembly
Overow Pipe
Water Tank Tab
Water Tank
Fig. 1
Actuator Paddle
Actuator Paddle
Bin Control Assembly
Silicone Hose