Instruction Manual
16
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or ice storage bin. The ice storage
bins listed below are recommended.
Model Number Bin Width Recommended Hoshizaki Ice Storage Bin
KM-340M_H
KM-515M_H
KM-600MAH
KM-650M_H
22" or Wider B-300 Series
KM-901M_H/3 30" or Wider B-500 Series
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specic application. For further
details, contact your local Hoshizaki distributor.
Model Number Recommended Hoshizaki Remote Condenser Unit
KM-515MRH
KM-650MRH
URC-5F
KM-901MRH/3 URC-9F
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push rearward
and lift off.
• Right Side Panel: Remove the screw. Slide forward
slightly and lift off.
• Insulation Panel: Lift up slightly and pull towards
you.
• Base Cover: Lift up slightly and pull towards you.
Fig. 1
Top Panel
Front
Panel
Screw
Insulation
Panel
Right Side Panel
Screw
Base Cover
Model Shown: KM-515MAH