Cleaning & Sanitizing

Cleaning Prep:
Remove the Front Panel, move the control switch to OFF.
After 3 min., move the switch to ICE, then replace the panel
.
After 3 min., remove the Front Panel, move the switch to OFF.
Remove all ice from the ice storage bin and/or dispenser.
WARNING! IF ON DISPENSER, turn off the dispenser power
supply after dispensing all the leftover ice.
Cleaning:
Remove the Front Insulation Panel, slide the Cube Guide to right. Remove the
Rubber Cap & Sleeve covering the Overflow Pipe. Unscrew the Overflow Pipe.
Once the water tank has drained, replace all the items.
Refill water tank by moving the control switch to ICE,
replace the Front Panel. After 3.5 minutes, remove
Front Panel, move switch to OFF.
Remove the Front Insulation Panels. Pour 30 fl.oz
(887 ml) of Hoshizaki Scale Away into the water tank.
Replace the Front Insulation Panels. Turn the
cleaning valve left until completely vertical (open).
NOTICE! AVOID EXCESSIVE FOAMING, wait 1 minute
before next step.
Move the control switch to WASH, replace Front Panel.
NOTICE! DO NOT leave the control switch on WASH
for extended periods when water tank is empty. It will
damage water pump seals.
After 30 minutes, remove Front Panel, then move the
control switch to OFF.
Ice Machine
KM-1100MAH, MWH, MRH
KM-1340MAH, MWH, MRH
KM-1601MRH/3
OPEN
Front of
Ice Maker
with
Front
Panel
removed
3.5
min.
30
min.
3
min
3
min.
Cleaning & Sanitizing
AMMONIA
Cleaners
The ice maker must be cleaned & sanitized at least once a year.
WARNING!
DO NOT leave icemaker unattended when
panels are off
 continued on the back…
Tech Support: 1.800.233.1940
1
2
3
4
Sanitizing:
• Fill the water tank
• CLOSE the cleaning valve
• Move control switch to ICE,
replace front panel
• After 3.5 minutes, remove
front panel
• Move control switch to OFF
• Remove the front insulation
panel
• Pour 1.7 fl. oz (50 ml) of
chlorine bleach* into the
water tank
• Replace the top, left, and
insulation panels
• OPEN the cleaning valve
* Use bleach without additives.
Additives cause excessive foaming, and
reduces effectiveness of the cleaning.
• Wait 1 minute to avoid
excessive foaming
• Move control switch to WASH,
replace front panel
• After 45 minutes, remove
front panel
• Move control switch to OFF
• Remove the front insulation
panel
• Slide the cube guide to right
• Remove rubber cap & sleeve
covering the overflow pipe
• Unscrew overflow pipe, drain
water tank
• Replace the rubber cap,
sleeve,
cube guide & insulation panel
14
15
16
17
18
5
6
7
#51003 | 4.05.2016
Page 1
Left side of
Ice Maker
View
through side
panel
8