Service Manual

43
Cam Switch Positioning
1) To adjust the cam switch position, loosen the bolts xing the switch bracket, and move
it to the left-or-right.
2) Check that the cam switch closes when the cam is in the location shown below.
Bolt
Cam
Contact when
cam opens 85°
Lever
Water Plate Switch
Bolt
Cam Switch
[j] Ice Guide
1) Remove the bolts xing the ice guide assembly to the actuator motor and the rear of
the bin.
2) Remove the screws xing the ice guide shaft.
3) Remove the plate from the ice guide.
4) Replace the ice guide.
5) Replace the removed parts in the reverse order of the removal procedure.
Switch
Bracket
Frame
Plate
Ice Guide
Ice Guide Assy
Bolt
Shaft