Service Manual

39
3. Icemaking Mechanism
1) Remove the front panel (lower).
2) Move the control switch to the “ICE” position, and press the “RESET” button. Then, the
water tank assembly starts to open.
3) While the water tank assembly stops to open and starts to close, move the control
switch to the “OFF” position, and unplug the appliance.
4) Remove the top panel, tope insulation, top cover, front frame and drain pan.
5) Replace the removed parts in the reverse order of the removal procedure.
[a] Actuator Motor Assembly
1) Remove the spring from the cam (A) in the actuator motor assembly.
2) Remove the bolts and nuts xing the actuator motor assembly bracket to the
mechanism base.
3) Pull o󰀨 the actuator motor assembly to disconnect the cam (A) from the cam shaft.
(The plastic spacer comes o󰀨 together with the actuator motor assembly.)
[b] Cam Shaft Assembly
1) Remove the spring from the cam shaft assembly.
2) Remove the bolts and nuts xing the bearing in the cam shaft assembly to the
mechanism base.
3) Pull out the cam shaft assembly from the bottom.
Shroud
Screw Hole for Condenser
Nut,
Spring Washer,
Washer
Fan
Nut
Fan Motor
Insertion to Base Hook
* Be sure to insert to replace the condenser in its correct position.
Bolt
3Dprt
B C
D E
F GA
6
5
3
4
2
1
A B C D E F G H
1
2
3
4
5
6
201802
3J
50 0 50
DRAWINGNo.
(30)
TITLE
(20)
メイショウ
図番
（ ）
DRAWN
DESIGNED
CHECKED
APPROVED
DATE SCALE
UNIT
mm
ホシザキ株式会社
HOSHIZAKICORPORATION
山崎
ファンモータAY
野津
石富
3Y9909 A
2017.05.17 石富 1:2
1
No. PARTSCODE NAME&SPEC. Q'TY Z
0 3Y9909A01 ファンモータAY 0
寸法区分
普通寸法公差（±）単位mm角度差（±）
指示なき取
付穴のピッ
チとその累
積公差は
O O
4以下 0.05 0.1 0.2 0.3 0.5 1 3 6
4をこえ16〃 0.1 0.2 0.3 0.5 0.7 1 2 3
16〃63〃 0.2 0.3 0.5 0.7 1.2 20' 1 2
63〃250〃 0.3 0.5 0.7 1.2 2.0 10' 20' 1
250〃1000〃 0.5 0.7 1.2 2.0 3.0 5' 10' 30'
1000をこえる 0.7 1.2 2.0 3.0 5.0 5' 10' 30'
J K L M N JK LM N
1
1 2018.05.09 注1:記載事項変更 長澤あ山崎
SYMBOL P DATE REVISION DESIGNED APPROVED
表
面
処
理
等

全
面
不動態化処理
焼痕除去
脱脂洗浄
焼痕銀粉塗布
バリ無きこと
／