Instruction Manual

16
11) Move the control switch to the “WASH“ position.
12) Slowly pour the cleaning solution over the top of the evaporator and into the water
tank. Do not splash or spill the solution onto other parts.
13) Replace the front panel and top panel in their correct positions.
14) Turn on the power supply to start the washing process.
15) Turn off the power supply after 30 minutes.
16) Open the icemaker water supply line shut-off valve. See Fig. 4.
17) Remove the front panel.
18) Move the control switch to the "ICE" position.
19) Replace the front panel.
20) Turn on the power supply for 3 minutes. The water tank drains.
21) Turn off the power supply.
22) Repeat steps 20 and 21 three more times to rinse thoroughly.
Note: If not sanitizing the icemaker, go to step 19 in “III. A. 2. Sanitizing Procedure.“
2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute a 5.25% sodium hypochlorite solution (chlorine bleach) with water (add
approximately 0.4 fl . oz. (12 ml) to 0.8 gal. (3.0 lit.) of water).
2) Close the icemaker water supply line shut-off valve. See Fig. 4.
3) Turn on the power supply for 3 minutes. The water tank drains.
4) Turn off the power supply.
5) Remove the front panel and top panel.
6) Move the control switch to the “WASH“ position.
7) Slowly pour the sanitizing solution over the top of the evaporator and into the water
tank. Do not splash or spill the solution onto other parts.
8) Replace the front panel and top panel in their correct positions.