Instruction Manual

13
7) Has the power supply voltage been checked or tested against the nameplate rating?
Has a proper ground been installed to the icemaker?
8) Are the water supply line shut-off valve and drain valve installed? Has the water supply
pressure been checked to ensure a minimum of 10 PSIG and a maximum of 113
PSIG?
9) Are the compressor hold-down bolts snug? Have the refrigerant lines been checked to
make sure they do not rub or touch other lines or surfaces?
10) Has the end user been given the instruction manual, and instructed on how to operate
the icemaker and the importance of the recommended periodic maintenance?
11) Has the end user been given the name and telephone number of an authorized service
agent?
12) Has the warranty card been filled out and forwarded to the factory for warranty
registration?
H. Startup
WARNING
1. All parts are factory-adjusted. Improper adjustments may adversely affect
safety, performance, component life, and warranty coverage.
2. Do not put your hands into the back of the storage bin or the baffl e on top
of the storage bin. Ice may drop off the icemaker, a hard block of ice may
suddenly break down, or the icemaking mechanism may suddenly move,
resulting in injury.
NOTICE
1. If the unit is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
2. To prevent damage to the water pump, do not leave the control switch in
the “WASH” position for extended periods of time when the water tank is
empty.
3. At startup, confirm that all internal and external connections are free of
leaks.