Instruction Manual

II. Installation and Operating Instructions

WARNING

• The appliance must be installed in accordance with applicable national, state, and

local codes and regulations.

• Failure to install, operate, and maintain the appliance in accordance with this

manual will adversely affect safety, performance, component life, and warranty

coverage and may result in costly water damage.

• CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews

are securely in place after installation. Make sure that none have fallen into the

dispenser unit/ice storage bin.

A. Location

NOTICE

• The icemaker is not intended for outdoor use. Normal operating ambient

temperature must be within 45°F to 100°F (7°C to 38°C); Normal operating

water temperature must be within 45°F to 90°F (7°C to 32°C). Operation of the

icemaker, for extended periods, outside of these normal temperature ranges may

affect icemaker performance.

• The icemaker will not work at sub-freezing temperatures. To prevent damage

to the water supply line, drain the icemaker if the air temperature is going to go

below 32°F (0°C). See "IV. Preparing the Icemaker for Periods of Non-Use."

For best operating results:

• The appliance should not be located next to ovens, grills, or other high heat producing

equipment.

• In areas where water damage is a concern, install in a contained area with a oor drain.

• Minimum Clearance:

Left Side and Top Right Side

Rear

2" (5-cm) on Left Side and 0" on Top

5/8" (16-mm) on Left Side and 2" (5-cm) on Top

6" (15-cm) 2" (5-cm)

• The location must provide a rm and level foundation for the appliance.