Instruction Manual
ELECTRICAL INSTALLATION
WARNING
• Electrical connecon must meet naonal, state, and local electrical code
requirements. Failure to meet these code requirements could result in
death, electric shock, serious injury, re, or severe damage to equipment.
• This appliance requires an independent power supply of proper
capacity. See the nameplate for electrical specicaons. Failure to use
an independent power supply of proper capacity can result in a tripped
breaker, blown fuse, damage to exisng wiring, or component failure.
This could lead to heat generaon or re.
• THIS APPLIANCE MUST BE GROUNDED: This appliance is equipped with a
NEMA 5-15 three-prong grounding plug to reduce the risk of potenal
shock hazards. It must be plugged into a properly grounded, independent
3-prong wall outlet. If the outlet is a 2-prong outlet, it is your personal
responsibility to have a qualied electrician replace it with a properly
grounded, independent 3-prong wall outlet. Do not remove the ground
prong from the plug and do not use an adapter plug. Failure to follow
these instrucons may result in death, electric shock, or re.
• To reduce the risk of electric shock, do not touch the plug with damp
hands.
• Do not use an extension cord.
• Do not use an appliance with a damaged power cord. The power cord
should not be altered, jerked, bundled, weighed down, pinched, or
tangled. Such acons could result in electric shock or re. To unplug the
appliance, be sure to pull the plug, not the cord, and do not jerk the cord.
• The GREEN ground wire in the factory-installed power cord is connected
to the appliance. If it becomes necessary to remove or replace the power
cord, be sure to connect the power cord’s ground wire.
Electrical Connecon
• Usually an electrical permit and services of a licensed electrician are required.
• The maximun allowable voltage variaon is ± 10 percent of the nameplate
rang.
ATTENTION
Aer an interrupon of the electrical power supply, the
compressor will take approximately 3 minutes to start
working.