Instruction Manual

33
4) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overow into the drain pan.
5) Remove the proximity switch from the chute assembly, then remove the chute assembly
from the icemaker.
6) Remove the packing at the bottom of the ice chute. Remove the 3 ties and the chute
insulation.
7) Soak the spout, O-ring, packings, chute bracket (FS-1022 and smaller), drip guide
(FS-1500 and larger), and chute in the sanitizing solution for 10 minutes then wipe them
down.
8) Rinse the parts thoroughly with clean water. NOTICE! If the solution is left on these
parts, they will rust.
9) Replace all parts in their correct positions.
10) Replace all panels except the front panel in their correct positions. Move the control
switch to the "ICE" position, then plug in the icemaker. Move the power switch to the
"ON" position, then replace the front panel in its correct position. Make ice using the
solution until the icemaker stops making ice.
11) Remove the front panel, then move the power switch to the "OFF" position. Move the
control switch to the "DRAIN" position, then move the power switch back to the "ON"
position. Replace the front panel in its correct position.
12) Allow the water system to drain for 5 minutes.
13) Remove the front panel. Move the power switch to the "OFF" position, then unplug the
unit from the electrical outlet.
3. Sanitizing Procedure - Final
1) Mix a new batch of the sanitizing solution.
2) Make sure the power switch is in the "OFF" position, the unit is unplugged from the
electrical outlet, and the water supply line shut-off valve is closed. Remove the top
panel.
3) Remove the strap connecting the spout to the chute assembly, then remove the spout.
4) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overow into the drain pan.
5) Replace the spout and strap in their correct positions.
6) Allow the icemaker to sit for about 10 minutes before operation.
7) Replace the top panel in its correct position. Move the control switch to the "ICE"
position, then plug in the icemaker. Move the power switch to the "ON" position, then
replace the front panel in its correct position. Make ice using the solution until the
icemaker stops making ice.
8) Remove the front panel, then move the power switch to the "OFF" position. Move the
control switch to the "DRAIN" position, then move the power switch back to the "ON"
position. Replace the front panel in its correct position.
9) Allow the water system to drain for 5 minutes.