Specifications Sheet

SERENITY SERIES CUBELET ICE MACHINE
Item #:
Project:
Qty:
AIA#:
618 Hwy, 74 S., Peachtree City, GA 30269 | TEL [phone] | FAX [phone] | www.hoshizakiamerica.com
© HOSHIZAKI AMERICA, INC.
Cubelet Cube Dimensions*
* approximate size in inches, image not to scale
• Up to 851 lbs. of ice production per 24 hours
• Durable stainless steel exterior
• EverCheck
TM
alert system
• No heat, less noise
• 2 second flush cycle every hour
• Flush cycle removes sediment for cleaner ice
• Slim depth - easier to clean dispenser
• Front and back serviceability
• 8 ft. power cord with NEMA 5-15P plug
• Compatible with Hoshizaki condenser or central
rack system
• R-404A Refrigerant
Remote Air-Cooled
FS-1001MLJ-C
• Ambient Temp Range 45 - 100°F
• Water Temp Range 45 - 90°F
• Water Pressure 10 - 113 PSIG
• Voltage Range 104-127V/187-253V*
Operating Limits
• Icemaker Water Supply Line: Minimum 1/4” Nominal ID
Copper Water Tubing or Equivalent
• Icemaker Drain Line: Minimum 3/4” Nominal ID Hard Pipe
or Equivalent
• Allow 24” (61 cm) clearance in both front and rear for proper
air circulation and ease of maintenance/service.
• For best performance the Remote Condenser should not be
more than 33 feet above the icemaker or no more than 10 feet
below it. These distances are measure from fitting to fitting.
Plumbing
Service
Hoshizaki reserves the right to change specifications without notice.
Printed in the U.S.A.
3 Year Parts & Labor on entire machine. 5 Year Parts on Compressor; air-cooled
condenser coil. Valid in United States, Canada, Puerto Rico and U.S. Territories.
Contact factory for warranty in other countries.
Warranty:
FS-1001MLJ-C
FS-1001MLJ-C
08/08/18
Item # 13211
Service-
SRC-10J
FS-1001MLJ-C FS-1001MLJ-C
FS-1001MLJ-C
• Allow 6” (15 cm) clearance at rear, sides, and top for
proper air circulation and ease of maintenance/service.
• Allow 24” (61 cm) clearance on left side for removal of
cube guides
• Panels easily removed and all components accessible
for service.
* Voltage supply for FS Ice Maker is
supplied from the SRC Remote Condenser
* Voltage supply for FS Ice Maker is
supplied from the SRC Remote Condenser
Features
Quiet operation - perfect for dining
area
Advanced CleanCycle24
TM
design
Stainless steel auger with greaseless
bearing
TM
1/2”
3/4”
3/4”
3/8”
Air / Water Temp
Lbs. per 24 hours
Condenser
Model
70°/ 50°F 90°/ 70°F
Potable
Gal. per 100 lbs.
Condenser
Gal. per 100 lbs.
Net / Ship
Weight (lbs.)
Voltage
90°/ 70°F 90°/ 70°F
90°/ 70°F
kWh Used
per 100 lbs.
Circuit
Wires
(including ground)
Refrigerant
Charge Amount
851
FS-1001MLJ-C
720
5.07
12.0 N/A 0lb. 3.5 oz. 126/166
115V/60/1*
Remote
25’ Length
Condenser
Model
LINE SETS - Brazing Required
35’ Length
55’ Length
Min. Circuit
Amp - Max.
Fuse/Breaker
Heat
Rejection
BTU/hr.
Voltage
ELECTRICAL
Ambient
Amperage
SRC-10J
-20° - 122°
20A
9,800208-230V/60/1
Remote
9.3A
(Outdoor Use)
Voltage
Range
187-253VAC
TEMP RANGE
Net / Ship
Weight (lbs.)
225 /270
Refrigerant
Charge Amount
15 lb. 14 oz.
Power cord included.
Circuit
Wires
(including ground)
4
HS-5299
†
HS-5300
†
HS-5301
†
†
Line sets require refrigerant. Refer to instruction manual for installation and electrical requirements. See instruction manual for wiring diagram.
SRC-10J
Volume:
34.75” x 15.75” X 32” 10.14ft
3
FS-1001MLJ-C Shipping: (LxWxH)
30" x 11" x 26"
W x D x H
SRC-10J
Installation Dimension*
SRC-10J
Remote Unit Dimension
38” x 29" x 37"
35
3/4
” x 23
1/2
” x 22”
*Dimensions include legs
Modular Head Unit
See remote
condenser
ICE PRODUCTION
WATER USAGE ELECTRICAL
Amperage
3.0A