Service Manual
Table Of Contents
- Important Safety Information
- I. Construction and Water/Refrigeration Circuit Diagram
- II. Sequence of Operation and Service Diagnosis
- III. Controls and Adjustments
- A. Control Board
- B. Controls and Adjustments
- 1. Default Dip Switch Settings
- 2. BC (Infrared Sensor) Shutdown Delay (S1 dip switch 1, 2, 3)
- 3. Drain Frequency Control (S1 dip switch 4)
- 4. Continuous Dispensing Timer (S1 dip switch 5 & 6)
- 5. Bin Control Selector (S1 dip switch 7)
- 6. BC (Mech. Stand-Alone or Backup (only)) Shutdown Delay (S1 dip switch 8)
- 7. Shutdown Sequence (S1 Dip Switch 9)
- 8. Factory Use (S1 Dip Switch 10)
- IV. Refrigeration Circuit and Component Service Information
- V. Maintenance
- VI. Disposal
- VII. Technical Information
45
FS-1022MLJ-C and FS-1500MLJ-C Evaporator Assembly
Removable Rubber Drip Pan
Fig. 7
Evaporator Heater
Auger
Seal Bolt
Socket Head Cap Screw and Split
Lock Washer
Gear Motor
Gear Motor Barrier
Lower Housing
O-Ring
Mechanical Seal
Spline Coupling
Hex Bolt and Washer
Socket Head Cap Screw and Split
Lock Washer
Lower Bearing
(pressed into lower housing)
Truss Head Screw
w/Rubber Washer
Drip Pan
Flange
Extruding Head
Cutter
Upper Bearing
(pressed into auger)
O-Ring