Instructions Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- A. Electrical and Refrigerant Data
- B. Dimensions/Connections
- 1. Air-Cooled Models (MAH(-C))
- 2. Water-Cooled Models (MWH(-C))
- 3. Remote Models (MRH(3)(-C))
- 4. Low Side, Parallel Rack System Models (MLH(-C))
- 5. Remote Condenser Unit URC-5F (use with F-1001MRH(-C))
- 6. Remote Condenser Unit URC-14F (use with F-1500MRH(-C))
- 7. Remote Condenser Unit URC-22F (use with F-2000MRH(3)(-C))
- II. Installation and Operating Instructions
- III. Maintenance
- IV. Preparing the Icemaker for Periods of Non-Use
- V. Disposal
34
Threads
Diaphragm
O-Ring
Fig. 16
Brush
Male Fitting
DO NOT USE
THREAD SEALANT
Backup
Wrench
Reference Line
1/6 Turn
Wrench
Wrench
Backup
Wrench
After Tight, Tighten an
Additional 1/6 Turn
Fig. 17
Suction Line (Insulated)
See "II.H.1 Line Set
Size and Rack System
Requirements" for
details.
Rack System-Threaded Connection
Fig. 15
Female Threaded Coupling
Rack System-Braze Connection
Male Threaded Fitting
Braze Connection
Liquid Line (Insulated)
See "II.H.1 Line Set
Size and Rack System
Requirements" for
details.
Suction Line (Insulated)
See "II.H.1 Line Set
Size and Rack System
Requirements" for
details.
Liquid Line (Insulated)
See "II.H.1 Line Set
Size and Rack System
Requirements" for
details.
Suction Line (Insulated)
See "II.H.1 Line Set Size and
Rack System Requirements"
for details.
Liquid Line (Insulated)
See "II.H.1 Line Set Size and
Rack System Requirements"
for details.
Icemaker
Male Fitting
Service Loop
F-1001MLH(-C)
Female Coupling
(Charging Ports)
Icemaker
Male Fitting
Service Loop
F-2000MLH(-C)
Female Coupling
(Charging Ports)
Suction Line (Insulated)
See "II.H.1 Line Set Size and
Rack System Requirements"
for details.
Liquid Line (Insulated)
See "II.H.1 Line Set Size and
Rack System Requirements"
for details.
Apply POE Oil or
Parker Super O Lube
to Entire Male Fitting