Instructions Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- A. Electrical and Refrigerant Data
- 1. F-300BAJ
- 2. F-500BAJ
- B. Dimensions/Connections
- 1. F-300BAJ
- 2. F-500BAJ
- II. Installation and Operating Instructions
- A. Location
- B. Checks Before Installation
- C. How to Remove Panels
- D. Setup
- E. Electrical Connection
- F. Water Supply and Drain Connections
- G. Final Checklist
- H. Startup
- I. Bin Control Check
- J. Alarm Safeties
- III. Maintenance
- A. Maintenance Schedule
- B. Cleaning and Sanitizing Instructions
- IV. Preparing the Appliance for Periods of Non-Use
- V. Disposal
26
5. Sanitizing Procedure - Final
1) Mix a new batch of the sanitizing solution.
2) Remove spout B and gasket B, then remove spout A and gasket A.
3) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the overow hose on the
reservoir.
4) Allow the icemaker to sit for 10 min. before operation.
5) Replace gasket A, spout A, gasket B, and spout B in their correct positions.
6) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position. Replace the front and top panels in their correct positions. Make ice using the
solution until the icemaker stops making ice.
7) Remove the top and front panels.
8) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Next, move the power switch to the "ON" position. Replace the front
and top panels in their correct positions. Allow the water system to drain for 5min.
9) After the water system has drained, remove the top and front panels, then move the
power switch to the "OFF" position.
10) Move the control switch to the "ICE" position.
11) Move the power switch to the "ON" position, then replace the top and front panels in
their correct positions.
12) Open the water supply line shut-off valve to supply water to the reservoir.
13) After the gear motor starts, remove the top and front panels.
14) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Next, move the power switch to the "ON" position. Replace the front
and top panels in their correct positions. Allow the water system to drain for 5 min.
15) After the water system has drained, remove the top and front panels, then move the
power switch to the "OFF" position.
16) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position to start the automatic icemaking process, then replace the top and front panels
in their correct positions. Allow the icemaker to run for 30 min.
17) After 30 min., remove the top and front panels and move the power switch to the "OFF"
position.
18) Pour warm water into the ice storage bin to melt all of the ice. Clean the ice storage bin
liner thoroughly using a neutral cleaner. Rinse thoroughly after cleaning.
19) Move the power switch to the "ON" position to start the automatic icemaking process.
20) Replace the top and front panels in their correct positions.