Instructions Manual

25
3. Sanitizing Solution
Dilute 2.5 . oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 5 gal. (19 l) of warm water. This is a minimum amount. Make more solution
if necessary. IMPORTANT! For safety and maximum effectiveness, use the solution
immediately after dilution.
4. Sanitizing Procedure - Initial
1) Make sure the power switch is in the "OFF" position and the icemaker water supply line
shut-off valve is closed.
2) Remove the top and front panels. Remove spout B and gasket B, then remove spout A,
gasket A, and the evaporator packing.
3) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the overow hose on the
reservoir.
4) Remove the snap pin, shaft, actuator, and bin control bracket from the bin top cover.
5) Remove the sliding door.
6) Soak the sliding door, spouts, gaskets, evaporator packing, snap pin, shaft, actuator,
and bin control bracket in .25gal. (1 l) of sanitizing solution for 10 min., then wipe them
down.
7) Rinse the parts thoroughly with clean water. NOTICE! If the solution is left on these
parts, they will rust.
8) Replace all parts in their correct positions.
9) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position. Replace the front and top panels in their correct positions. Make ice using the
solution until the icemaker stops making ice.
10) Remove the top and front panels.
11) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Next, move the power switch to the "ON" position. Replace the front
and top panels in their correct positions. Allow the water system to drain for 5min.
12) After the water system has drained, remove the top and front panels, then move the
power switch to the "OFF" position.