Instructions Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- A. Electrical and Refrigerant Data
- 1. F-300BAJ
- 2. F-500BAJ
- B. Dimensions/Connections
- 1. F-300BAJ
- 2. F-500BAJ
- II. Installation and Operating Instructions
- A. Location
- B. Checks Before Installation
- C. How to Remove Panels
- D. Setup
- E. Electrical Connection
- F. Water Supply and Drain Connections
- G. Final Checklist
- H. Startup
- I. Bin Control Check
- J. Alarm Safeties
- III. Maintenance
- A. Maintenance Schedule
- B. Cleaning and Sanitizing Instructions
- IV. Preparing the Appliance for Periods of Non-Use
- V. Disposal
16
G. Final Checklist
WARNING
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after installation. Make sure that none have fallen into the ice
storage bin.
1) Is the icemaker level?
2) Is the icemaker in a site where the ambient temperature is within 45°F to 100°F (7°C to
38°C) and the water temperature within 45°F to 90°F (7°C to 32°C) all year around?
3) Is there at least 6" (15 cm) at the rear and sides and 24" (61 cm) at the top of the
appliance for maintenance and service?
4) Have the shipping carton, tape, and packing material been removed from the
appliance?
5) Have all electrical and water connections been made? Do electrical and water
connections meet all national, state, and local code and regulation requirements?
6) Has the power supply voltage been checked or tested against the nameplate rating?
Is the power supply a properly grounded, independent 3-prong wall outlet on corded
models, or has a proper ground been installed to the icemaker on hard-wired models?
7) Are the water supply and drain lines sized as specied? Are the water supply line
shut-off valve and drain valve installed? Has the water supply pressure been checked to
ensure a minimum of 10 PSIG and a maximum of 113 PSIG?
8) Are all components, fasteners, and thumbscrews securely in place?
9) Has the end user been given the instruction manual, and instructed on how to operate
the appliance and the importance of the recommended periodic maintenance?
10) Has the end user been given the contact information of an authorized service agent?
11) Has the warranty card been lled out and forwarded to the factory for warranty
registration?