Instruction Manual

19
8) Remove spout B, then remove spout A. See Fig. 5.
9) Pour the cleaning solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the overow hose on the
reservoir.
Note: If there is excess scale on the extruding head, ll the evaporator assembly and
reservoir as described above, then use a clamp on the reservoir hose between
the reservoir and evaporator assembly to block ow. Pour additional cleaning
solution over the extruding head until the evaporator assembly is completely full.
10) Allow the appliance to sit for about 10 minutes before operation. If you placed a clamp
on the reservoir hose in step 9, remove it before operation.
11) In bad or severe water conditions, clean the oat switch as described below. Otherwise,
continue to step 12.
a. Remove the oat switch from the reservoir cover.
b. Wipe down the oat switch with the cleaning solution.
c. Rinse the oat switch thoroughly with clean water.
d. Replace the oat switch in its correct position.
12) Replace all parts and the top panel.
13) Plug the appliance back in. Move the control switch to the "ICE" position, then move the
power switch to the "ON" position. Replace the front panel and allow the appliance to
make ice using the solution until it stops automatically.
14) Remove the front panel.
15) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Move the power switch to the "ON" position to drain the remainder of
the solution.
16) After the solution has drained, move the control switch to the "ICE" position.
17) Replace the front panel.
Fig. 5
Evaporator Assembly
Spout
Packing A
Cylinder Packing
Extruding Head
Spout A
Thumbscrew
Spout B
Thumbscrew