Instruction Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- A. Electrical and Refrigerant Data
- B. Dimensions/Connections
- II. Installation and Operating Instructions
- A. Location
- B. Checks Before Installation
- C. How to Remove Panels
- D. Setup
- E. Electrical Connection
- F. Water Supply and Drain Connections
- G. Final Checklist
- H. Startup
- I. Bin Control Check
- J. Alarm Safeties
- III. Maintenance
- A. Maintenance Schedule
- B. Cleaning and Sanitizing Instructions
- 1. Cleaning Solution
- 2. Cleaning Procedure
- 3. Sanitizing Solution
- 4. Sanitizing Procedure - Initial
- 5. Sanitizing Procedure - Final
- IV. Preparing the Appliance for Periods of Non-Use
- V. Disposal
13
H. Startup
WARNING
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
NOTICE
• If the appliance is turned off, wait for at least 3 minutes before restarting the
appliance to prevent damage to the compressor.
• At startup, conrm that all internal and external connections are free of leaks.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Make sure the power switch in the "OFF" position. Plug the appliance into the electrical
outlet.
4) Move the control switch to the "ICE" position, then move the power switch to the "ON"
position. Replace the front panel.
5) Once the appliance starts to produce ice, allow it to run for another 30 minutes.
6) Remove the front panel.
7) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Move the power switch to the "ON" position to drain the appliance.
8) After the water has drained, move the power switch to the "OFF" position. Unplug the
appliance.
9) Pour warm water into the ice storage bin and melt any remaining ice. Clean the ice
storage bin liner using a neutral cleaner. Rinse thoroughly after cleaning.
10) Conrm bin control operation. See "II.I. Bin Control Check."