Instruction Manual

21
5) Remove the bin control assembly from the top insulation and set it aside. Remove the
top insulation.
6) Remove spout B, then remove spout A.
7) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the overow hose on the
reservoir.
8) Allow the appliance to sit for about 10 minutes before operation.
9) Replace all parts and the top panel.
10) Plug the appliance back in. Move the control switch to the "ICE" position, then move the
power switch to the "ON" position. Replace the front panel and allow the appliance to
make ice using the solution until it stops automatically.
11) Remove the front panel.
12) Move the power switch to the "OFF" position, then move the control switch to the
"DRAIN" position. Move the power switch to the "ON" position to drain the remainder of
the solution.
13) After the solution has drained, move the control switch to the "ICE" position.
14) Replace the front panel.
15) Open the water supply line shut-off valve to supply water to the reservoir.
16) After the gear motor starts, remove the front panel. Move the power switch to the "OFF"
position, then move the control switch to the "DRAIN" position. Move the power switch
to the "ON" position to drain the appliance.
17) After the water has drained, move the control switch to the "ICE" position and allow the
appliance to run. Replace the front panel.
18) After 30 minutes, remove the front panel and move the power switch to the "OFF"
position. Unplug the appliance.
19) Pour warm water into the ice storage bin to melt all ice, then clean the bin liner with the
solution.
20) Rinse out any solution from the ice storage bin.
21) Plug the appliance back in. Move the power switch to the "ON" position to start the
automatic icemaking process.
22) Replace the front panel.