Instruction Manual Self-Contained Flaker Models F-330BAJ(-C) hoshizakiamerica.
WARNING Only qualified service technicians should install and service the appliance. To obtain the name and phone number of your local Hoshizaki Certified Service Representative, visit www.hoshizaki.com. No installation or service should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to operate the appliance until the installer has instructed them on its proper operation.
IMPORTANT This manual should be read carefully before the appliance is installed and operated. Read the warnings and guidelines contained in this manual carefully as they provide essential information for the continued safe use and maintenance of the appliance. Retain this manual for any further reference that may be necessary. CONTENTS Important Safety Information.................................................................................................. 4 I. Specifications..........................
Important Safety Information Throughout this manual, notices appear to bring your attention to situations which could result in death, serious injury, damage to the appliance, or damage to property. WARNING Indicates a hazardous situation which could result in death or serious injury. NOTICE Indicates a situation which could result in damage to the appliance or property. IMPORTANT Indicates important information about the installation, use, and care of the appliance.
WARNING, continued • Do not make any alterations to the appliance. Alterations could result in electric shock, injury, fire, or damage to the appliance. • Do not place fingers or any other objects into the ice discharge opening.
I. Specifications A. Electrical and Refrigerant Data 1. F-330BAJ(-C) The rating label and nameplate provide electrical and refrigerant data. The rating label can be seen by removing the front panel. The nameplate is located on the rear panel. For certification marks, see the nameplate. We reserve the right to make changes in specifications and design without prior notice. Model Number AC Supply Voltage Amperes Design Pressure Refrigerant F-330BAJ 115/60/1 6.9 AMPS HI-470PSI LO-230PSI 404A 7.1 OZ.
B. Dimensions/Connections Unit: in. (mm) 1.
II. Installation and Operating Instructions WARNING • The appliance must be installed in accordance with applicable national, state, and local codes and regulations. • Failure to install, operate, and maintain the appliance in accordance with this manual will adversely affect safety, performance, component life, and warranty coverage and may result in costly water damage. • CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation.
C. How to Remove Panels See Fig. 1 • Front Panel: Remove the screw. Lift up and towards you. • Top Panel: Open the door. Remove the screws. Lift up at the front slightly, push rearward, and lift off. Top Panel Screws Door Front Panel Fig. 1 Screw D. Setup 1) Attach the four adjustable legs provided to the bottom of the appliance. 2) Position the appliance in the selected permanent location. 3) Level the appliance from side-to-side and front-to-rear by adjusting the legs.
E. Electrical Connection WARNING • Electrical connection must meet national, state, and local electrical code requirements. Failure to meet these code requirements could result in death, electric shock, serious injury, fire, or damage. • The appliance requires an independent power supply of proper capacity. See the nameplate for electrical specifications.
F. Water Supply and Drain Connections See Fig. 2 WARNING Water supply and drain connections must be installed in accordance with applicable national, state, and local regulations. NOTICE • Normal operating water temperature must be within 45°F to 90°F (7°C to 32°C). Operation of the appliance, for extended periods, outside of this normal temperature range may affect appliance performance. • Water supply pressure must be a minimum of 10 PSIG and a maximum of 113 PSIG.
G. Final Checklist WARNING CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after installation. Make sure that none have fallen into the ice storage bin.
H. Startup WARNING All parts are factory-adjusted. Improper adjustments may adversely affect safety, performance, component life, and warranty coverage. NOTICE • If the appliance is turned off, wait for at least 3 minutes before restarting the appliance to prevent damage to the compressor. • At startup, confirm that all internal and external connections are free of leaks. 1) Open the water supply line shut-off valve. 2) Remove the front panel. 3) Make sure the power switch in the "OFF" position.
I. Bin Control Check 1) If not already removed, remove the front panel. 2) Make sure the power switch is in the "OFF" position. Plug the appliance into the electrical outlet. 3) Move the control switch to the "ICE" position, then move the power switch to the "ON" position. 4) Allow the appliance to run until the compressor starts (approximately 5 minutes). 5) Engage the actuator located in the ice storage bin. See Fig. 3. 90-sec. compressor shutdown time starts. Once the 90-sec.
J. Alarm Safeties Should an alarm occur, follow the instructions in the table below to address the alarm. If an alarm continues to occur, contact an authorized service agent. WARNING • Only qualified service technicians should service the appliance. • To reduce the risk of electric shock, do not touch the icemaker power switch, control switch, or plug with damp hands. • Before Servicing: Move the icemaker's power switch to the "OFF" position, then unplug the appliance. No.
III. Maintenance The appliance must be maintained in accordance with the instruction manual and labels provided with the appliance. Consult with your local Hoshizaki Certified Service Representative about maintenance service. WARNING • Only qualified service technicians should service the appliance. • To reduce the risk of electric shock, do not touch the power switch, control switch, or plug with damp hands.
A. Maintenance Schedule The maintenance schedule below is a guideline. More frequent maintenance may be required depending on water quality, the appliance's environment, and local sanitation regulations. Maintenance Schedule Frequency Area Task Daily Bi-Weekly Monthly Clean the scoop using a neutral cleaner. Rinse thoroughly after cleaning. Inspect. Wash with warm water and neutral cleaner if dirty. Check for proper pressure and change if necessary.
B. Cleaning and Sanitizing Instructions The appliance must be cleaned and sanitized at least twice a year. More frequent cleaning and sanitizing may be required in some conditions. WARNING • To prevent injury to individuals and damage to the appliance, do not use ammonia type cleaners. • Carefully follow any instructions provided with the cleaning and sanitizing solutions.
8) Remove spout B, then remove spout A. See Fig. 5. Spout Packing A Thumbscrew Spout A Extruding Head Evaporator Assembly Fig. 5 Cylinder Packing Spout B Thumbscrew 9) Pour the cleaning solution over the extruding head until the evaporator assembly and the reservoir are full and the solution starts to run through the overflow hose on the reservoir.
18) Open the water supply line shut-off valve to supply water to the reservoir. 19) After the gear motor starts, remove the front panel. Move the power switch to the "OFF" position, then move the control switch to the "DRAIN" position. Move the power switch to the "ON" position to drain the appliance. 20) After the water has drained, move the power switch to the "OFF" position. Unplug the appliance.
5) Remove the bin control assembly from the top insulation and set it aside. Remove the top insulation. 6) Remove spout B, then remove spout A. 7) Pour the sanitizing solution over the extruding head until the evaporator assembly and the reservoir are full and the solution starts to run through the overflow hose on the reservoir. 8) Allow the appliance to sit for about 10 minutes before operation. 9) Replace all parts and the top panel. 10) Plug the appliance back in.
IV. Preparing the Appliance for Periods of Non-Use NOTICE When storing the appliance for an extended time or in sub-freezing temperatures, follow the instructions below to prevent damage. When the appliance is not used for two or three days under normal conditions, it is sufficient to only move the power switch to the "OFF" position. When storing the appliance for extended time or in sub-freezing temperatures, follow the instructions below.
V. Disposal When disposing of the appliance, follow the instructions below. WARNING Remove the door to reduce the risk of children getting trapped. This appliance contains refrigerant and must be disposed of in accordance with applicable national, state, and local codes and regulations. Refrigerant must be recovered by properly certified service personnel.
618 Hwy. 74 South, Peachtree City, GA 30269 USA (P) 770.487.2331 (F) 770.487.3360 hoshizakiamerica.
