Instruction Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- A. Electrical and Refrigerant Data
- B. Dimensions/Connections
- 1. Air-Cooled Models (MAH/MAJ(-C))
- 2. Water-Cooled Models (MWH(-C))
- 3. Remote Models (MRH/MRJ(3)(-C)) and Low-Side Models (MLH(-C))
- 4. Remote Condenser Unit URC-5F (use with FD-1001MRJ-C)
- 5. Remote Condenser Unit URC-14F (use with F-1501MRH(-C))
- 6. Remote Condenser Unit URC-22F (use with F-2001MRH(3)(-C))
- II. Installation and Operating Instructions
- A. Location
- B. Checks Before Installation
- C. How to Remove Panels
- D. Dispenser Unit/Ice Storage Bin and Icemaker Setup
- E. Electrical Connection
- F. Water Supply and Drain Connections
- G. Installation of Remote Condenser Unit for Remote Models
- H. Connection to an R-404A Parallel Rack System for Low-Side Models
- I. Final Checklist
- J. Startup
- K. Bin Control Check
- L. Alarm Safeties
- III. Maintenance
- IV. Preparing the Icemaker for Periods of Non-Use
- V. Disposal
32
Liquid Line (Insulated)
See "II.H.1 Line Set Size and Rack
System Requirements" for details.
Suction Line (Insulated)
See "II.H.1 Line Set Size and Rack
System Requirements" for details.
Female Coupling
(Charging Ports)
Icemaker
Male Fitting
Service Loop
Fig. 16
Fig. 15
Fig. 17
Apply POE Oil or
Parker Super O Lube
to Entire Male Fitting
Threads
Diaphragm
O-Ring
Brush
Male Fitting
DO NOT USE
THREAD SEALANT
Backup
Wrench
Reference
Line
1/6
Tu r n
Wrench
Wrench
After Tight, Tighten an
Additional 1/6 Turn
Backup
Wrench
Braze Connection
Rack System-Braze Connection