Instruction Manual
Table Of Contents
- Important Safety Information
- I. Specifications
- II. Installation and Operating Instructions
- A. Location
- B. Checks Before Installation
- C. How to Remove Panels
- D. Dispenser Unit/Ice Storage Bin and Icemaker Setup
- E. Electrical Connection
- F. Water Supply and Drain Connections
- G. Remote Condenser Unit Installation
- H. Parallel Rack System Connection
- I. Final Checklist
- J. Startup
- K. Bin Control Check
- L. Alarm Safeties
- III. Maintenance
- IV. Preparing the Appliance for Periods of Non-Use
- V. Disposal
42
III. Maintenance
The appliance must be maintained in accordance with the instruction manual and labels
provided. Consult with your local Hoshizaki Certied Service Representative about
maintenance service.
WARNING
• Only qualied service technicians should service the appliance.
• To reduce the risk of electric shock, do not touch the icemaker power switch or
control switch with damp hands.
• Before Servicing: Move the icemaker's power switch to the "OFF" position. Turn off
the power supply. Place the disconnect (if applicable) in the off position.
Lockout/Tagout to prevent the power supply from being turned back on
inadvertently.
• CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after any maintenance is done to the appliance. Make sure that
none have fallen into the dispenser unit/ice storage bin.
Fig. 20
Spout
Chute
Packing
Chute Insulation
Extruding Head
Evaporator
Assembly
Reservoir
Ties
(Hook and Loop)
Float Switch
Rubber O-Ring
(F-650 and Larger)
Nylon Ring
(F-650 and Larger)
Evaporator
Condensate
Drain Pan
Infrared Sensor Lens
Evaporator Packing
(F-450 Only)
Upper Spout Strap
Spout-to-Chute Packing
Spout-to-Chute Bracket
(F/FD-1002 and Smaller)
Lower Spout Strap
Reservoir Hose
Overow Hose
Reservoir
Cover
Drip Guide
(F-1501M_J(_C) and F-2002M_J(-C) )